Auto Dry Cabinet is a plug and play, fully auto dry cabinet which will
be stable at 60°Cand ＜1%RH. It is especially designed for moisture sensitive SMD
packages to comply with
Baking 60°CAuto Dry Cabinet with 4 main functions: Wider application in resetting the floor life: Moisture sensitivity SMD
packages which are exposed to the air and exceed the floor life should
be stored in the T40W-480 for resetting the floor life. (see
table 4-1, 4-3.) For example: If MSD parts of MSD Level 4,5 and 5a
are exposed for less than eight hours, they can be stored in a dry
cabinet for resetting the floor life. However, if their exposure time is
longer than eight hours, the SMD packages should be stored at 40°C
in a T60W-480 to reset the floor
life. Labor saving: SMD packages
shipped in low temperature carriers may not be baked in a traditional
high temperature oven with the temperature higher than 40°C,
as it will cause deformation of the carriers. Storing in a T40W-480,
operators do not need to remove the SMD package to thermally safer
carriers. It saves labor cost and eliminates the chance of damaging the
carriers. Embedded Alarm: The
temperature or relative humidity of interior cabinet exceeds the preset
value will activate the embedded alarm of buzz and flash in the control
panel. Memo cards: Special "Slash
Door" design to allow inserting the memo cards which can record the
necessary storage information of MSD management.
Temperature & Humidity
Recovery time (Open door 30
Open door 30 seconds
and close, 10 mins recovery time to ＜10%RH, 30 mins recovery time to
External dimensions (mm)
No. of shelves
BAKING CABINET (40
Baking Cabinet Model
Humidity Manager V2 for drawing the curve of RH and temperature.
thick carbon steel with antistatic paint.
airtight magnetic sealers and antistatic glass.
Wheel: four antistatic 3” wheels, two of them
1MΩ. (940mm long)
103~109Ω. (surface resistance)
provide Baking 60°CAuto Dry Cabinet in customers' design.